Quick Contact

Badminton Close, Naunton Lane, Leckhampton,
Cheltenham, Gloucestershire GL53 7BX UK
Tel: +44 (0) 1242 243006
Fax: +44 (0) 1242 222487

e.mail:
info@nixonflowmeters.co.uk

Click for contact page

SP3 Pulse Amplifier

The SP3 Signal Conditioner has been designed for applications where simple amplification of the output of an inductive coil is required. Typical applications include signal boosting where electrical interference along the signal cable run could cause spurious readings, or where long transmission lengths lead to attenuation of low level outputs.

Click here to download the PDF file for full details

The unit is very lightweight and can be attached to any suitable surface with a self adhesive pad. Wiring is easily carried out to the integral terminal block.

The unit operates as a three wire system using a DC supply. The unit is not intended for use in exposed
conditions. For applications where additional environmental protection is necessary, it must be
provided by the user during installation..

Advantages

 Economic alternative to expensive pre-amplifiers •  Minimal installation requirements •  Compact Design •  Suitable for retro fitting •  Output suitable for most instrumentation

Specification


 Dimensions 40 x 50 x 20 mm •  Weight 60 Grams •  Supply Voltage 10-40 V DC •  Operating Temperature 0-80oC •  Minimum Input level 12 mV •  Output Signal Square wave 0-(supply Voltage) at input frequency

Connections to Terminal Block 
1.  Vs+ Power Supply
2.  OV
3.  Square wave output pulse
4.  Input a from pick off coil
5.  Input b from pick off coil
6.  Screen from pick off coil cable
 ch programming.



Related Products